Tripod Automatic Systems Turnstiles Sunscreen Polishing Esd
Turnstile System
1. With fault self-check and alarm prompt function, convenient for
user maintenance and use.
2. It can be connected with any control signal or button and remote
control output by any control device to achieve one-way and two-way
control.
3. One-way and two-way free passage can be set arbitrarily.
4. Automatically reset every 120 degrees of rotation, the system
will automatically cancel the authority of this passage when it
doesn't pass within the specified time (adjustable delay).
5. High-intensity traffic light status indication.
6. Connect with fire alarm signal.
7. Accurate signal memory, when receiving legal signals multiple
times in a row, it will automatically reset after the last person
passes.
8. It will automatically give alarm prompt when illegal traffic or
sluice gate.
9. Automatically drop the pole when power off, automatically load
the pole when power is on.
10. Reader
| Frequency:13.56KHz | Response Time: Less than 0.2 seconds |
| DIM:Length85.6mm × Width53.98mm × Thickness1.8mm | cable length: 250mm |
| Material:Hard Shell = ABS；Cover Foil = PVC | Weight: 60g |
| Color:White , black, grey, blue, yellow | Wiring : |
| Power requirements: 5-16VDC at 100mA, A linear regulator is
recommended | Red: Power 5-16V |
| Interface: Weigand | Black: Power ground |
| Reader range: 5 - 10 cm | Green: Wiegand output D0 |
| Frequency: 122-128KHz | White: Wiegand output D1 |
| Operation temperature: -30 C to +60 C | Brown: Green LED control |
| operationg humidity: 5%-95% relative humidity non-condensing | Blue: Buzzer control |
| Audio/Visual Indication: Green & Red and Buzzer signal output | Yellow: Hold |
LED/Buzzer function description
LED function: The LED color is normally in RED. It starts with 2
green flashes on power up the reader and remains RED. When a RFID
proximity card is present to the reader, The LED will momentary
flash green,this indicates that the card was read properly by the
reader. When the LED control signal is active, the LED changes to
green.
Beeper Function: Power up the reader, the beeper will active 2
times. When a RFID proximity card is present to the reader, a short
beep will be emitter. This indicates that the card was read
properly by the reader. When the Buzzer control signal is active,
the buzzer will sound till buzzer control line is released
Hold function: when this line is asserted,(made low by HOST) the
reader will buffer one card read (ignoring subsequent reads) until
the line is released.(made high or open)
